Giriş Yap
    Alışveriş Sepetim
    Kategoriler
    39,1
    42

    Teltonika TE-RUTX14 4G LTE CAT12 Endüstriyel Hücresel Router

    Teltonika TE-RUTX14 4G LTE CAT12 Endüstriyel Hücresel Router
    Görsel 1
    PlatinPuan : 16.836.347
    Fiyat:
    21.266,96 TL
    Havale / EFT:
    20.735,29 TL
    2.764,70 TL'den başlayan taksit seçenekleri için tıklayın.
    Aynı Gün Kargo

    Ürüne Oy Verin

    Teltonika TE-RUTX14 4G LTE CAT12 Endüstriyel Hücresel Router

     
    MOBILE
    Mobile module4G (LTE) – Cat 12 up to 600 Mbps, 3G – up to 42 Mbps
    SIM/mobile module switch2 SIM cards, auto switch cases: weak signal, data limit, SMS limit, roaming, no network, network denied, data connection fail
    StatusSignal strength, SINR, RSRP, RSRQ, Bytes sent/received, connected band, carrier aggregation, IMSI, ICCID,
    SMSSMS status, SMS configuration, send/read SMS via HTTP POST/GET, Email to SMS, SMS to Email, SMS to HTTP, SMS to SMS, SMS auto replay
    Black/White list (planned)Operator black/white list
    Multiple PDNPossibility to use different PDNs for multiple network access and services
    Band managementBand lock, Used band status display
    APNAuto APN
    Bridge modeDirect connection (bridge) between mobile ISP and device on LAN
    WIRELESS
    Wireless mode802.11b/g/n/ac Wave 2 (WiFi 5) with data transmission rates up to 867 Mbps (Dual Band, MU-MIMO), 802.11r fast transition, Access Point (AP), Station (STA)
    WiFi securityWPA3-EAP, WPA3-SAE, WPA2-Enterprise-PEAP, WPA2-PSK, WEP; AES-CCMP, TKIP, Auto Cipher modes, client separation
    ESSIDESSID stealth mode
    WiFi usersup to 150 simultaneous connections
    Wireless HotspotCaptive portal (Hotspot), internal/external Radius server, built in customizable landing page
    ETHERNET
    WAN1 x WAN port (can be configured as LAN) 10/100/1000 Mbps, compliance with IEEE 802.3, IEEE 802.3u, 802.3az standards, supports auto MDI/MDIX crossover
    LAN4 x LAN ports, 10/100/1000 Mbps, compliance with IEEE 802.3, IEEE 802.3u, 802.3az standards, supports auto MDI/MDIX
    BLUETOOTH
    Bluetooth 4.0Bluetooth low energy (LE) for short range communication
    NETWORK
    RoutingStatic routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, EIGRP, NHRP)
    Network protocolsTCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet client, SNMP, MQTT, Wake on LAN (WOL), DLNA
    VoIP passthrough supportH.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets
    Connection monitoringPing Reboot, Wget reboot, Periodic Reboot, LCP and ICMP for link inspection
    FirewallPort forwards, traffic rules, custom rules
    DHCPStatic and dynamic IP allocation, DHCP Relay, Relayd
    QoS / Smart Queue Management (SQM)Traffic priority queuing by source/destination, service, protocol or port, WMM, 802.11e
    DDNSSupported >25 service providers, others can be configured manually
    Network backupVRRP, Mobile, Wired and WiFi WAN options, each of which can be used as an automatic Failover
    Load balancingBalance Internet traffic over multiple WAN connections
    SSHFSPossibility to mount remote file system via SSH protocol
    SECURITY
    AuthenticationPre-shared key, digital certificates, X.509 certificates
    FirewallPre-configured firewall rules can be enabled via WebUI, unlimited firewall configuration via CLI; DMZ; NAT; NAT-T
    Attack preventionDDOS prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack prevention), port scan prevention (SYN-FIN, SYN-RST, X-mas, NULL flags, FIN scan attacks)
    VLANPort and tag based VLAN separation
    Mobile quota controlCustom data limits for both SIM cards
    WEB filterBlacklist for blocking out unwanted websites, Whitelist for specifying allowed sites only
    Access controlFlexible access control of TCP, UDP, ICMP packets, MAC address filter
    VPN
    OpenVPNMultiple clients and a server can run simultaneously, 12 encryption methods
    OpenVPN EncryptionDES-CBC, RC2-CBC, DES-EDE-CBC, DES-EDE3-CBC, DESX-CBC, BF-CBC, RC2-40-CBC, CAST5-CBC, RC2-64-CBC, AES-128-CBC, AES-192-CBC, AES-256-CBC
    IPsecIKEv1, IKEv2, with 5 encryption methods for IPsec (DES, 3DES, AES128, AES192, AES256)
    GREGRE tunnel
    PPTP, L2TPClient/Server instances can run simultaneously, L2TPv3 support
    StunnelProxy designed to add TLS encryption functionality to existing clients and servers without any changes in the program’s code
    DMVPNMethod of building scalable IPsec VPNs
    SSTPSSTP client instance support
    ZeroTierZeroTier VPN client support
    WireGuardWireGuard VPN client and server support
    MODBUS TCP SLAVE
    ID filteringRespond to one ID in range [1;255] or any
    Allow remote accessAllow access through WAN
    Custom registersModbus TCP custom register block, which allows to read/write to a file inside the router, and can be used to extend Modbus TCP slave functionality
    MODBUS TCP MASTER
    Supported functions01, 02, 03, 04, 05, 06, 15, 16
    Supported data formats8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC), HEX, ASCII
    MQTT GATEWAY
    GatewayAllows sending commands and receiving data from MODBUS Master through the MQTT broker
    DNP3
    Supported modesTCP Master, DNP3 Outstation
    DATA TO SERVER
    ProtocolsHTTP(S), MQTT, Azure MQTT, Kinesis
    IoT PLATFORMS
    Clouds of thingsAllows monitoring of: Device data, Mobile data, Network info, Availability
    ThingWorxAllows monitoring of: WAN Type, WAN IP Mobile Operator Name, Mobile Signal Strength, Mobile Network Type
    CumulocityAllows monitoring of: Device Model, Revision and Serial Number, Mobile Cell ID, ICCID, IMEI, Connection Type, Operator, Signal Strength, WAN Type and IP
    Azure IoT HubCan send device IP, Number of bytes send/received/ 3G connection state, Network link state, IMEI, ICCID, Model, Manufacturer, Serial, Revision, IMSI, Sim State, PIN state, GSM signal, WCDMA RSCP, WCDMA EC/IO, LTE RSRP, LTE SINR, LTE RSRQ, CELL ID, Operator, Operator number, Connection type, Temperature, PIN count to Azure IoT Hub server
    MONITORING & MANAGEMENT
    WEB UIHTTP/HTTPS, status, configuration, FW update, CLI, troubleshoot, event log, system log, kernel log
    FOTAFirmware update from server, automatic notification
    SSHSSH (v1, v2)
    SMSSMS status, SMS configuration, send/read SMS via HTTP POST/GET
    CALLReboot, Status, Mobile data on/off, Output on/off
    TR-069OpenACS, EasyCwmp, ACSLite, tGem, LibreACS, GenieACS, FreeACS, LibCWMP, Friendly tech, AVSystem
    MQTTMQTT Broker, MQTT publisher
    SNMPSNMP (v1, v2, v3), SNMP trap
    JSON-RPCManagement API over HTTP/HTTPS
    MODBUSMODBUS TCP status/control
    RMSTeltonika Remote Management System (RMS)
    SYSTEM CHARACTERISTICS
    CPUQuad-core ARM Cortex A7, 717 MHz
    RAM256 MB, DDR3
    FLASH storage256 MB, SPI Flash
    FIRMWARE / CONFIGURATION
    WEB UIUpdate FW from file, check FW on server, configuration profiles, configuration backup
    FOTAUpdate FW/configuration from server
    RMSUpdate FW/configuration for multiple devices at once
    Keep settingsUpdate FW without losing current configuration
    FIRMWARE CUSTOMIZATION
    Operating systemRutOS (OpenWrt based Linux OS)
    Supported languagesBusybox shell, Lua, C, C++
    Development toolsSDK package with build environment provided
    LOCATION TRACKING
    GNSSGPS, GLONASS, BeiDou, Galileo and QZSS
    CoordinatesGNSS coordinates via WebUI, SMS, TAVL, RMS
    NMEANMEA 0183
    Server softwareSupported server software: TAVL, RMS
    GeofencingConfigurable multiple geofence zones
    USB
    Data rateUSB 2.0
    ApplicationsSamba share, USB-to-serial
    External devicesPossibility to connect external HDD, flash drive, additional modem, printer
    Storage formatsFAT, FAT32, NTFS
    INPUT/OUTPUT
    Input1 x Digital Input, 0 - 6 V detected as logic low, 8 - 30 V detected as logic high
    Output1 x Digital Output, Open collector output, max output 30 V, 300 mA
    EventsSMS, Email, RMS
    I/O jugglerAllows to set certain I/O conditions to initiate event
    POWER
    Connector4 pin industrial DC power socket
    Input voltage range9 – 50 VDC, reverse polarity protection, voltage surge/transient protection
    PoE (passive)Passive PoE. Possibility to power up through LAN1 port, not compatible with IEEE802.3af, 802.3at and 802.3bt standards
    Power consumptionIdle: <4 W, Max: <22 W
    PHYSICAL INTERFACES (PORTS, LEDS, ANTENNAS, BUTTONS, SIM)
    Ethernet5 x RJ45 ports, 10/100/1000 Mbps
    I/Os1 x Digital Input, 1 x Digital Output on 4 pin power connector
    Status LEDs2 x connection status LEDs, 3 x connection strength LEDs, 10 x Ethernet port status LEDs, 4 x WAN status LEDs, 1x Power LED, 2 x 2.4G and 5G WiFi LEDs
    SIM2 x SIM slots (Mini SIM - 2FF), 1.8 V/3 V, external SIM holders
    Power1 x 4 pin DC connector
    Antennas4 x SMA for LTE, 2 x RP-SMA for WiFi, 1 x RP-SMA for Bluetooth, 1 x SMA for GNNS
    USB1 x USB A port for external devices
    ResetReboot/User default reset/Factory reset button
    Other1 x Grounding screw
    PHYSICAL SPECIFICATION
    Casing materialFull aluminium housing
    Dimensions (W x H x D)132 x 44 x 95 mm
    Weight515 g
    Mounting optionsDIN rail (can be mounted on two sides), flat surface placement
    OPERATING ENVIRONMENT
    Operating temperature-40 C to 75 C
    Operating humidity10 % to 90 % non-condensing
     
    Diğer Özellikler
    Stok KoduTE-RUTX14
    MarkaTELTONIKA
    Stok DurumuVar
    4779027312965

    PlatinMarket® E-Ticaret Sistemi İle Hazırlanmıştır.